LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Fuel Filler Pocket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Filler Pocket
    GM1479949Courtesy of GENERAL MOTORS CORP.
  1. Align the fuel filler pocket (1) to the body panel (2).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws (3, 4) to the fuel filler pocket to the left body panel.

    Tighten:  Tighten the screws to 10 N.m (89 lb in).

  3. Install the push in retainer to the fuel filler pocket.
  4. Install the fuel cap to the fuel filler pocket.
  5. Close the fuel filler door.
scientia non olet · About LEMON Manuals