Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Releasing/Securing Fuel Filler Door Innerlock Cable

Courtesy of GENERAL MOTORS CORP.

Connect the fuel filler innerlock cable (2) to the fuel filler innerlock bracket.
Insert the fuel filler innerlock into the keyhole slot (1) to the body.
Slide the fuel filler innerlock bracket toward the rear of the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolt (3) to the fuel filler innerlock bracket.
Tighten: Tighten the fuel filler door innerlock bracket retaining bolt to 25 N.m (18 lb ft).
Close the sliding door.
Verify fuel filler door operation.