LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Bumper Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Passenger Side Liftgate Bumper
    GM1479952Courtesy of GENERAL MOTORS CORP.
  1. Position the bumper to the right hand body panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screw.

    Tighten:  Tighten the screw to 10 N.m (89 lb in).

  3. Close the liftgate.
scientia non olet · About LEMON Manuals