Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear corner upper garnish molding. Refer to Finish Panel Replacement - Upper Rear Trim .
- Disconnect the electrical connector from the rear quarter window actuator (1).
- Remove the rear quarter window actuator retaining bolts (2).
- Remove the screw that attaches the actuator arm to the window.
- Remove the actuator from the vehicle.