LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Body Rear End) >> Repair Instructions >> Actuator Replacement - Rear Quarter Window >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Rear Quarter Window Actuator
    GM1480111Courtesy of GENERAL MOTORS CORP.
  1. Position the actuator assembly (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screw that attaches the actuator arm to the window.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  3. Install the rear quarter window actuator retaining bolts (2).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Connect the electrical connector to the rear quarter window actuator.
  5. Install the rear corner upper garnish molding. Refer to Finish Panel Replacement - Upper Rear Trim .
scientia non olet · About LEMON Manuals