LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Replacement (Long Wheel Base) >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP purge pipe (6) into the fuel tank clip.
  2. Install the fuel feed pipe (1) into the fuel tank pipe clips.
  3. Install the fuel tank module (3). Refer to Fuel Tank Module Replacement (Long Wheel Base) .
  4. Install the EVAP canister vent solenoid (2). Refer to Evaporative Emission Canister Vent Solenoid Valve Replacement Long Wheel Base .
  5. Install the EVAP canister. Refer to Evaporative Emission Canister Replacement - Long Wheel Base  .
scientia non olet · About LEMON Manuals