LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Pressure Sensor
    GM1480291Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor.
  2. Connect the fuel sender wiring harness electrical connector to the fuel tank pressure sensor.
  3. Install the fuel tank. Refer to Fuel Tank Replacement (Short Wheel Base)  or Fuel Tank Replacement (Long Wheel Base) .
scientia non olet · About LEMON Manuals