Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fuel & EVAP Line

Courtesy of GENERAL MOTORS CORP.

Install the fuel and EVAP pipes (1).

Fig 2: Removing/Installing Fuel/EVAP Pipe At Clips

Courtesy of GENERAL MOTORS CORP.

Install the fuel/EVAP pipe clips to the studs.

Fig 3: Identifying Fuel/EVAP Pipe Clip

Courtesy of GENERAL MOTORS CORP.

Install the fuel/EVAP pipe clip to the stud.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the fuel/EVAP pipe clip nut.
Tighten: Tighten the nut to 20 Nm (15 lb ft).
Perform the following procedures if equipped with auxiliary rear air and heat.
1. Move the rear heater and A/C pipes into their original position.
2. Connect the rear heater and A/C pipes to the rear HVAC module. Refer to HVAC MODULE REPLACEMENT - AUXILIARY .

Fig 4: Identifying Fuel Tank Feed Pipe Quick Connect Fitting

Courtesy of GENERAL MOTORS CORP.

Connect the fuel feed (1) and EVAP (2) pipes to the fuel tank. Refer to Plastic Collar Quick Connect Fitting Service .
Install the engine and transmission as an assembly. Refer to ENGINE REPLACEMENT .