LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fill Pipe/Fuel Fill Pocket Bolts
    GM1682276Courtesy of GENERAL MOTORS CORP.
  1. Drain the fuel tank. Refer to Fuel Tank Draining .
  2. Remove the fuel fill pipe to fuel fill pocket bolts.
  3. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
    4. Fig 2: Identifying Fill Pipe Shields & Retainers/Fuel Fill Pocket Bolts
    GM1682277Courtesy of GENERAL MOTORS CORP.
  4. Remove the fuel fill pipe shield retainers.
  5. Remove the fuel fill pipe shield.
    6. Fig 3: Identifying Fuel Tank Fill Hose & Clamp
    GM1682044Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel fill pipe bracket bolt (1).
  7. Disconnect the fuel fill pipe vapor recirculation pipe (2) quick connect fitting from the fuel tank vapor recirculation hose (3). Refer to Plastic Collar Quick Connect Fitting Service .
  8. Loosen the fuel fill hose clamp (5) at the fuel tank.
  9. Remove the fuel fill hose from the fuel tank (4).
  10. Remove the fuel fill pipe assembly.
scientia non olet · About LEMON Manuals