Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fuel & EVAP Line

Courtesy of GENERAL MOTORS CORP.

Install the fuel and EVAP pipes (1).

Fig 2: Removing/Installing Fuel/EVAP Pipe At Clips

Courtesy of GENERAL MOTORS CORP.

Install the fuel/EVAP pipe clips to the studs.

Fig 3: Identifying Fuel/EVAP Pipe Clip

Courtesy of GENERAL MOTORS CORP.

Install the fuel/EVAP pipe clip to the stud.

Fig 4: Identifying Fuel/EVAP Pipe Clip Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the fuel/EVAP pipe clip nut.
Tighten: Tighten the nut to 20 Nm (15 lb ft).
Perform the following procedures if equipped with auxiliary rear air and heat.
1. Move the rear heater and A/C pipes into their original position.
2. Connect the rear heater and A/C pipes from the rear heating, ventilation and air conditioning (HVAC) module. Refer to HVAC MODULE REPLACEMENT - AUXILIARY .
Connect the fuel feed (1) and EVAP (2) pipes to the fuel tank. Refer to Plastic Collar Quick Connect Fitting Service .
Install engine and transmission as an assembly. Refer to ENGINE REPLACEMENT .