LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Canister/Fuel Tank Short Wheel Base >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank And Related Components
    GM1544794Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Short Wheel Base) .
  2. Disconnect and remove the evaporative emission (EVAP) canister purge pipe (6) from the EVAP canister (1). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP canister vent solenoid pipe from the EVAP canister (1) and EVAP canister vent solenoid (2). Refer to Plastic Collar Quick Connect Fitting Service .
  4. Remove the EVAP canister vent solenoid pipe from the fuel tank.
  5. Disconnect the EVAP pipe assembly from the EVAP canister (1) and fuel sender module (3). Refer to Plastic Collar Quick Connect Fitting Service .
  6. Remove the EVAP pipe assembly from the fuel tank.
scientia non olet · About LEMON Manuals