LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement Short Wheel Base >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank And Related Components
    GM1544794Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent solenoid valve (2) onto the vent solenoid valve bracket. Pull on the valve to ensure tab is locked.
  2. Connect the EVAP vent hose to the vent solenoid valve.
  3. Connect the fuel tank harness electrical connector (4) to the vent solenoid valve.
  4. Install fuel tank. Refer to Fuel Tank Replacement (Short Wheel Base) .
scientia non olet · About LEMON Manuals