Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing ECT Sensor

Courtesy of GENERAL MOTORS CORP.

NOTE: components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

Coat the threads of the ECT sensor with sealer GM P/N 13246004 (Canadian P/N 10953480) or equivalent.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the ECT sensor.
Tighten: Tighten the ECT sensor to 20 Nm (15 lb ft).
Connect the ECT electrical connector.
Install the exhaust crossover pipe. Refer to EXHAUST CROSSOVER PIPE REPLACEMENT (3.9L) .
Install intake manifold cover, if necessary. Refer to INTAKE MANIFOLD COVER REPLACEMENT .
Fill the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM (STATIC FILL) .