LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Battery & Powertrain Control Module (PCM)
    GM1544730Courtesy of GENERAL MOTORS CORP.
  1. Connect the engine harness electrical connectors (4) to the ECM.
  2. Install the ECM (2) to the air cleaner cover.
  3. Install the air cleaner assembly cover.
  4. Install the air cleaner cover (1) to the air cleaner assembly (3) and tighten the cover screws.

    Tighten:   Tighten the screws to 4 Nm (35 lb in).

  5. Install left sheet metal diagonal brace. Refer to BRACE REPLACEMENT - SHEET METAL DIAGONAL
  6. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE .
  7. If a new ECM is being installed, program the EEPROM. Refer to Control Module References .
scientia non olet · About LEMON Manuals