LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Engine Controls - 3.9L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Replace the O-ring if damaged, lubricate the NEW O-ring with clean engine oil.
  2. Install the CMP sensor.
    3. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the CMP sensor bolt.

    Tighten:   Tighten the nuts to 10 Nm (89 lb in).

    4. Fig 1: Disconnecting/Connecting Camshaft Position (CMP) Sensor Electrical Connector
    GM1599076Courtesy of GENERAL MOTORS CORP.
  4. Connect the CMP sensor electrical connector.
  5. Install power steering pump. Refer to POWER STEERING PUMP REPLACEMENT .
scientia non olet · About LEMON Manuals