LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Wire Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Spark Plug Wire Routing Engine Right Side
    GM1299397Courtesy of GENERAL MOTORS CORP.
  1. Install the spark plug wires (1,3 and 5) to the ignition coils.
  2. Install the spark plug wires (1,3 and 5) to the engine right side spark plugs.
  3. Install the spark plug wires to the retaining clip.
  4. Rotate engine back to original position. Refer to Rotating the Engine for Service Access .
    5. Fig 2: Spark Plug Wire Routing Engine Left Side
    GM1299208Courtesy of GENERAL MOTORS CORP.
  5. Install the spark plug wires (2,4 and 6) to the ignition coils.
  6. Install the spark plug wires (2,4 and 6) to the engine left side spark plugs.
  7. Install the spark plug wires to the retaining clips.
scientia non olet · About LEMON Manuals