LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting/Reconnecting Manifold Absolute Pressure (MAP) Sensor Electrical Connector
    GM1544767Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).
    2. Fig 2: Identifying MAP Sensor Retaining Bolt & Bracket
    GM1544765Courtesy of GENERAL MOTORS CORP.
  2. Remove the MAP sensor retaining bolt (3) and bracket (2).
  3. Remove the MAP sensor (1) and the MAP sensor port seal if it is still retained in the intake manifold.
scientia non olet · About LEMON Manuals