LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying MAP Sensor Retaining Bolt & Bracket
    GM1544765Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor (1) to the intake manifold.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the MAP sensor retaining bracket (2) and bolt (3).

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Disconnecting/Reconnecting Manifold Absolute Pressure (MAP) Sensor Electrical Connector
    GM1544767Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAP sensor electrical connector (2).
scientia non olet · About LEMON Manuals