LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing 4 Screws Securing Ignition Coil And Module Assembly To Bracket
    GM1238999Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil and module assembly to the bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ignition coil and module assembly screws.

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires as noted during the removal.
  4. Connect the brake booster vacuum hose from the intake manifold.
scientia non olet · About LEMON Manuals