LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Replacement (Long Wheel Base) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Tank And EVAP Components
    GM1544795Courtesy of GENERAL MOTORS CORP.
  1. Place the fuel tank in a suitable work area.
  2. Remove the EVAP canister (2). Refer to Evaporative Emission (EVAP) Canister Replacement (Short Wheel Base)  or Evaporative Emission (EVAP) Canister Replacement (Long Wheel Base) .
  3. Remove the EVAP canister vent valve (3). Refer to Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (Short Wheel Base)  or Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (Long Wheel Base) .
  4. Remove the fuel sender assembly (4). Refer to Fuel Sender Assembly Replacement (Short Wheel Base)  or Fuel Sender Assembly Replacement (Long Wheel Base) .
  5. Remove the fuel feed pipe (1) from the fuel tank pipe clips.
  6. Remove the EVAP purge pipe (6) from the fuel tank pipe clip.
scientia non olet · About LEMON Manuals