LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.
    Fig 1: Locating Fuel Filler Pipe To Fuel Fill Pocket Bolts
    GM724421Courtesy of GENERAL MOTORS CORP.
  1. Drain the fuel tank. Refer to Fuel Tank Draining Procedure .
  2. Remove the fuel filler pipe to fuel fill pocket bolts.
  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Remove the fuel filler pipe shield.
    5. Fig 2: Locating Fuel Filler Pipe Components
    GM724404Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel filler pipe bracket bolt (1).
  6. Disconnect the vent pipe (3).
  7. Remove the fuel filler hose from the fuel tank (4).
  8. Remove the fuel filler pipe and hose.
scientia non olet · About LEMON Manuals