LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Filler Pipe Components
    GM724404Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the fuel filler pipe and hose to the fuel tank (4). Fully seat the fill hose to the stop on the tank.

    Tighten:  Tighten the fuel filler pipe clamp to 2.5 N.m (22 lb in).

  2. Connect the vent pipe (3).
  3. Install the fuel filler pipe bracket bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

    4. Fig 2: Locating Fuel Filler Pipe To Fuel Fill Pocket Bolts
    GM724421Courtesy of GENERAL MOTORS CORP.
  4. Install the fuel filler pipe shield.
  5. Lower the vehicle.
  6. Install the fuel filler pipe to fuel fill pocket bolts.
  7. Refill the fuel tank.
  8. Install the fuel filler cap.
  9. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Engine Electrical.
  10. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals