LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank (Short Wheel Base) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank And Related Components
    GM1544794Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP pipe assembly to the fuel tank.
  2. Connect the EVAP pipe assembly to the EVAP canister (1) and fuel sender module (3).
  3. Install the EVAP canister vent solenoid pipe to the fuel tank.
  4. Connect the EVAP canister vent solenoid pipe to the EVAP canister (1) and EVAP canister vent solenoid (2).
  5. Install and connect the EVAP canister purge pipe (6) to the EVAP canister (1).
  6. Install the fuel tank. Refer to Fuel Tank Replacement (Long Wheel Base)  or Fuel Tank Replacement (Short Wheel Base) .
scientia non olet · About LEMON Manuals