LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Engine Controls - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the O-ring with clean engine oil. Replace the O-ring if the O-ring is damaged.
    2. Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice.
  2. Install the CMP sensor.

    Tighten:  Tighten the retaining bolt to 8 N.m (71 lb ft).

  3. Connect the CMP sensor electrical connector.
  4. Install the power steering pump. Refer to Power Steering Pump Replacement .
scientia non olet · About LEMON Manuals