Ignition Control Module (ICM)/Coils
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
There are 3 dual-tower ignition coils that are part of the ignition control module (ICM). The ICM contains coil driver circuits that command the coils to operate. The ICM has the following circuits:
- An ignition voltage circuit
- A ground circuit
- An IC 1 control circuit for the 1-4 ignition coil
- An IC 2 control circuit for the 2-5 ignition coil
- An IC 3 control circuit for the 3-6 ignition coil
- A low reference circuit
The powertrain control module (PCM) controls each dual-tower ignition coil by transmitting timing pulses on the ignition control (IC) circuit to the ICM for the proper coil to enable a spark event.
The spark plugs are connected to each coil tower by spark plug wires. The spark plug wires conduct the spark energy from the coil to the spark plug. The spark plug electrode is tipped with platinum for long wear and higher efficiency.