LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 183 (General Information) >> Introduction >> Lifting and Jacking the Vehicle >> Lifting the Vehicle with a Frame-Contact Lift >> Front Hoist Pad

Front Hoist Pad

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Lifting Vehicle With Frame-Contact Lift
GM255944Courtesy of GENERAL MOTORS CORP.
IMPORTANT: The front hoist pads must not contact the rocker panels, the front fenders, the floor pan or the stone guard moldings.

When lifting the vehicle with a frame-contact lift, place the front lift pads at the front longitudinal frame rails. These areas are identified on the vehicle with an equilateral triangle.