Enabling Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the key from the ignition.
- Connect the vehicle harness connector (4) to the RR side impact module yellow connector (1).
- Install the CPA to the RR side impact module connector (1).
- Install the Air Bag Fuse.
- Install the cover for the underhood fuse center.
- Use caution while reaching in and turning the ignition switch to the ON position.
The AIR BAG indicator will flash, then turn OFF.
- Perform the Diagnostic System Check - Vehicle, if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle .