Test Description
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 2: This step checks for any current PPS DTCs.
- 3: This step checks for the presence of DTC B1530.
- 4: This step replaces the SDM.
- 5: This step performs the SDM setup procedure.
DTC B1530
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: SIR Schematics (AK5 or AJ7) or SIR Schematics (AW9) Connector End View Reference: SIR Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
IMPORTANT:
If the sensing and diagnostic module (SDM) has DTC B0092 or DTC B0098 stored as current, you must address those DTCs before continuing with this diagnostic table.
|
Go to Diagnostic Trouble Code (DTC) List - Vehicle | Go to Step 3 |
| 3 | If the passenger presence system (PPS) has been replaced then DTC B1530 will automatically be cleared. If the PPS was repaired and DTC B1530 is current, the SDM will have to be replaced. Is DTC B1530 a current DTC? |
Go to Step 4 | System OK |
| 4 | Replace the SDM. Refer to Control Module References
for replacement, setup and programming. Did you complete the replacement? |
Go to Step 5 | - |
| 5 | Perform the Setup SDM Serial Number in body control module (BCM) procedure. Refer to Control Module References
for replacement, setup and programming. Did you complete the setup procedure? |
System OK | - |