Diagnostic Aids

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

DTC B0053 will be accompanied by another DTC, other than DTC B1000 and DTC B0051. Repair the malfunction causing the other DTCs before installing a new SDM.

DTC B0053

Step	Action	Yes	No
Schematic Reference: SIR Schematics (AK5 or AJ7) or SIR Schematics (AW9)
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn OFF the ignition. Inspect the vehicle for signs of inflator module deployment. Does the vehicle show any signs of inflator module deployment?	Go to Step 5	Go to Step 3
3	Inspect the front of the vehicle and undercarriage for signs of impact/collision. Does the vehicle show any signs of impact/collision?	Go to Step 5	Go to Step 4
4	Replace the inflatable restraint sensing and diagnostic module (SDM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming. Did you complete the replacement?	Go to Step 6	-
5	Install a scan tool. With a scan tool, observe the SIR DTC display. If a history DTC exists, refer to Diagnostic Aids for that specific DTC and diagnose the problem. Replace components and perform inspections as required following an accident. Refer to Repairs and Inspections Required After a Collision . Did you complete the action?	Go to Step 6	-
6	Reconnect all SIR components. Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC, as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK