LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Cruise Control System) >> Diagnostic Information and Procedures >> DTC P1574 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

In order to avoid a misdiagnosis, inspect for proper operation of the stop lamps. Refer to Exterior Lighting Systems Description and Operation in Lighting Systems.

For an intermittent condition, refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems.

DTC P1574

Step Action Yes No
Schematic Reference: Cruise Control Schematics 
Connector End View Reference: Engine Controls Connector End Views or Powertrain Control Module (PCM) Connector End Views in Engine Controls - 3.5L (LX9)
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 Is DTC P0573 current in the powertrain control module (PCM)? Go to DTC P0573 in Lighting Systems Go to Step 3 
3 Do the stop lamps operate properly? Go to Step 4  Go to Stop Lamps Inoperative in Lighting Systems
4
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, observe the Stoplamp Status parameter in the Body and Accessories Cruise Control data list.
Does the Stoplamp Status parameter display On?
Go to Step 5  Go to Diagnostic Aids
5 Test the stop lamp switch signal circuit for an open or for a high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 6 
6 Inspect for poor connections at the harness connector of the throttle actuator control (TAC) module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.
Did you find and correct the condition?
Go to Step 8  Go to Step 7 
7 Replace the TAC module. Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming.
Did you complete the replacement?
Go to Step 8  -
8
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC.
Does the DTC reset?
Go to Step 2  System OK