LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Engine Control System - 3.6L (Ly7) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Evaporative Emission (EVAP) Line
    GM1575957Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the evaporative emission (EVAP) line (3) from the canister. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
    3. Fig 2: EVAP Canister Hose Clamp
    GM1575959Courtesy of GENERAL MOTORS CORP.
  3. Reposition the EVAP canister hose clamp.
  4. Remove the EVAP canister hose.
    5. Fig 3: EVAP Canister Line
    GM1575960Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the EVAP canister line from the fuel sender. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  6. Squeeze the small retainer in front of the canister in order to disengage the canister.
  7. Remove the EVAP canister.
scientia non olet · About LEMON Manuals