LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Body Lock Pillar Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the speaker wire harness connector.
  2. Align the locator tabs on the upper trim panel with the rear quarter trim panel.
    3. Fig 1: View Of Body Pillar Upper Trim Panel
    GM313671Courtesy of GENERAL MOTORS CORP.
  3. Align the upper trim panel retainers with the holes and push to secure the panel to the vehicle.
  4. Align the slider door seal to the body pillar upper trim panel if applicable.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the upper seat belt anchor bolt to the belt guide loop.

    Tighten:  Tighten the bolt to 43 N.m (32 lb ft).

scientia non olet · About LEMON Manuals