LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Interior Trim) >> Repair Instructions >> Finish Panel Replacement - Upper Rear Trim >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Back Body Pillar Trim
    GM449920Courtesy of GENERAL MOTORS CORP.
  1. Remove the upper seat belt anchor bolt from the belt guide loop.
    2. IMPORTANT: Use care to not break the locating tabs on the quarter trim when removing the back body pillar trim.
  2. Using J 38778  remove the back body pillar trim from the vehicle.
scientia non olet · About LEMON Manuals