LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 178 (Interior Trim) >> Repair Instructions >> Finish Panel Replacement - Upper Rear Trim >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Back Body Pillar Trim
    GM449920Courtesy of GENERAL MOTORS CORP.
  1. Install the back body pillar trim by aligning the trim with the locating tabs on the quarter trim.
  2. Align the retainers in the holes and push to secure the retainers.
    3. NOTE: Refer to Fastener Notice .
  3. Install the upper seat belt anchor bolt to the belt guide loop.

    Tighten:  Tighten the bolt to 43 N.m (32 lb ft).

scientia non olet · About LEMON Manuals