LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel (I/P) Harness Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Instrument Panel Harness
    GM318305Courtesy of GENERAL MOTORS CORP.
  1. Align the wiring harness retainers.
  2. Push in on the wiring harness (2) until the harness is secure.
    3. IMPORTANT: Ensure that the electrical connectors are routed correctly through the instrument panel.
  3. Install the I/P. Refer to Instrument Panel (I/P) Assembly Replacement .
  4. Connect the wiring harness connectors under the I/P.
  5. Connect the wiring harness connectors under the hood.
  6. Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 .
scientia non olet · About LEMON Manuals