LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Instrument Panel (I/P) Carrier Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 .
  2. Disconnect the negative battery cable. Refer to ENGINE ELECTRICAL .
  3. Remove the instrument panel (I/P). Refer to Instrument Panel (I/P) Assembly Replacement .
  4. Disconnect the I/P wiring harness connectors and position out of the way. Refer to Instrument Panel (I/P) Harness Replacement .
  5. Remove the body control module (BCM). Refer to Body Control Module Replacement .
  6. Remove the I/P air outlet ducts. Refer to Instrument Panel (I/P) Air Outlet Ducts Replacement .
  7. Remove the center air outlet. Refer to Air Outlet Replacement - Center .
  8. Remove the defroster duct. Refer to Air Outlet Duct Replacement - Defroster .
  9. Remove the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located under the right side window defogger duct.
  10. Remove the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located under the left side window defogger duct.
  11. Remove the bolt holding the HVAC module to the bracket on the I/P carrier, this bolt is located on the rear right center of the I/P carrier.
  12. Remove the bolt holding the brake pedal bracket on the I/P carrier, this bolt is located on the upper rear side of the bracket.
  13. Remove the ground wire bolts on the lower I/P carrier on the right and left sides.
  14. Remove the bolts holding the steering column support bracket on the cowl panel brace.
    15. Fig 1: View Of Bolts/Screws For IP Carrier And Cross Vehicle Beam To Hinge Pillar
    GM482588Courtesy of GENERAL MOTORS CORP.
  15. Remove the bolts/screws which secure the I/P carrier to the body.
  16. Remove the I/P carrier from the body.
scientia non olet · About LEMON Manuals