Compartment, Door, Latch, Panel, Mat Replacement - Front Floor Console (Uplevel)

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Compartment, Door, Latch, Panel & Mat - Front Floor Console (Uplevel)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice . Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .
Front Floor Console Trim Panel Replacement
1	Panel, Front Floor Console Trim
10	Clip, Front Floor Console (Qty: 6)
Front Floor Console Compartment Replacement
1	Panel, Front Floor Console Trim
2	Compartment, Front Floor Console Tip: Remove the front floor console spring from the trim panel. Pull upward to separate the hinge that holds the console compartment to the trim panel.
Front Floor Console Compartment Door Replacement
3	Screw, Front Floor Console Compartment Door (Qty: 4) Tighten: 2 N.m (18 lb in)
4	Door, Front Floor Console Compartment
Front Floor Console Compartment Door Latch Replacement
3	Screw, Front Floor Console Compartment Door (Qty: 4) Tighten: 2 N.m (18 lb in)
4	Door, Front Floor Console Compartment
5	Latch, Front Floor Console Compartment Door
Front Floor Console Compartment Mat Replacement
6	Mat, Front Floor Console Compartment
Front Floor Console Receptacle Assembly Replacement
7	Cap and Tether, Front Floor Console Receptacle
8	Receptacle, Front Floor Console Tip: Pull the receptacle out of the front floor console using the J 42059 Cigar Lighter Socket Remover. Disconnect the electrical connector.
9	Retainer, Front Floor Console Receptacle