LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Accessory Trim Plate, Driver Information Display Switch Replacement - Instrument Panel

Accessory Trim Plate, Driver Information Display Switch Replacement - Instrument Panel

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Instrument Panel Accessory Trim Plate & Driver Information Display Switch
GM1495430Courtesy of GENERAL MOTORS CORP.
Accessory Trim Plate, Driver Information Display Switch Replacement - Instrument Panel

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .
Instrument Panel (I/P) Accessory Trim Panel Replacement 
1 Panel, I/P Accessory Trim
2 Clip, I/P Accessory Trim Panel (Qty: 5)
Driver Information Center Display Switch Replacement 
1 Panel, I/P Accessory Trim
3 Outlet Assembly, I/P A/C Center
Tip: 
  1. Pull rearward of the instrument panel (I/P) to remove.
  2. Disconnect electrical connectors from the switches.
4 Screw, Driver Information Center Display Switch

Tighten:  2 N.m (18 lb in)

5 Switch Assembly, Driver Information Center Display