LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 177 (Instrument Panel System Displays, Gauges And Console) >> Diagnostic Information and Procedures >> Low Fuel Indicator Inoperative

Low Fuel Indicator Inoperative

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
Low Fuel Indicator Inoperative

Step Action Yes No
Schematic Reference: Instrument Cluster Schematics 
Connector End View Reference: Instrument Panel, Gages and Console Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With the scan tool, perform the Lamp Test in the instrument panel cluster (IPC) Special Functions.
Does the low fuel indicator illuminate when commanded ON?
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3 Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup and programming.
Did you complete the replacement?
Go to Step 4  -
4 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2