LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Steering Wheel & Steering Column) >> Repair Instructions >> Wire Harness Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to the coil assembly.
  1. Remove the steering column. Refer to Steering Column Replacement .
  2. Disconnect all the electrical connectors.
    3. Fig 1: View Of Wiring Harness In Steering Column Harness Strap
    GM322946Courtesy of GENERAL MOTORS CORP.
  3. Remove all the wire harness straps (2).
  4. Remove the wire harness from the steering column.
scientia non olet · About LEMON Manuals