LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Position Sensor or Steering Shaft Lower Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: A new sensor must come with a pin installed. If pin is not installed, return and reorder sensor.
    Fig 1: Aligning Sensor Onto The Steering Shaft And Into The Bearing Adapter
    GM835314Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not apply force to the sensor (1) or the bearing adapter (3) in a sideways direction.
  1. If reusing the sensor, with the pin still installed, align the sensor onto the steering shaft (2) and into the bearing adapter (3).
    2. IMPORTANT: If installing a new sensor the sensor will come pre-centered. Do not remove the pin until installation is complete.
  2. Install the sensor onto the steering shaft (2) and into the bearing adapter (3).
  3. The sensor must be set to approximately 3 mm gap between the sensor and the bearing adapter.
  4. Install the sensor connector.
  5. Remove the pin from the sensor.
  6. Install the intermediate shaft to the steering column. Refer to Intermediate Steering Shaft Replacement .
  7. Install the steering column to the vehicle. Refer to Steering Column Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals