LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 175 (Steering Wheel & Steering Column) >> Repair Instructions >> Seal Replacement - Intermediate Steering Shaft >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intermediate shaft lower seal over the intermediate shaft and to the steering gear.
  2. Install the intermediate shaft upper seal over the lower seal and to the instrument panel.
  3. Connect the intermediate shaft to the steering column. Refer to Intermediate Steering Shaft Replacement .
  4. Connect the intermediate shaft seal to the steering column.
    5. Fig 1: Locating Intermediate Shaft Seal Bolts
    GM294379Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the intermediate shaft seal bolts.

    Tighten:  Tighten the bolts to 3 N.m (27 lb in).

  6. Install the dash insulator.
  7. Remove the J 42640  from the steering column. See Special Tools .
scientia non olet · About LEMON Manuals