LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Door System, Mirror System & Window System) >> Repair Instructions >> Weatherstrip Replacement - Sliding Door Window (Swing Out) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.
  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Remove the sliding door swing out window. Refer to Window Replacement - Sliding Door Swing Out .
    3. Fig 1: View Of Sliding Door Window Weatherstrip
    GM320079Courtesy of GENERAL MOTORS CORP.
  3. Pull the sliding door window weatherstrip from the pinch-weld flange.
  4. Remove the sliding door window weatherstrip from the sliding door.
scientia non olet · About LEMON Manuals