LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Door System, Mirror System & Window System) >> Repair Instructions >> Roller Bracket Replacement - Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sliding Door Upper Roller Bracket
    GM319976Courtesy of GENERAL MOTORS CORP.
  1. Install the sliding door upper roller bracket to the front edge of the upper track.
    2. Fig 2: Identifying Upper Roller Bracket
    GM1480571Courtesy of GENERAL MOTORS CORP.
  2. Align the sliding door upper roller bracket (1) to the grease pencil marks.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the sliding door upper roller bracket bolts.

    Tighten:  Tighten the sliding door upper roller bracket bolts, in sequence as shown, to 10 N.m (89 lb in).

  4. Remove the support from the sliding door.
  5. Adjust the sliding door, if needed. Refer to Door Adjustment - Sliding (Manual or Power) .
  6. Install the headliner trim finish molding. Refer to Headlining Trim Finish Molding Replacement in Interior Trim.
  7. Install the sliding door garnish molding. Refer to Garnish Molding Replacement - Sliding Door in Interior Trim.
scientia non olet · About LEMON Manuals