LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Door System, Mirror System & Window System) >> Repair Instructions >> Roller Bracket Replacement - Lower >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.
  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Remove the front edges of the sliding door inner trim panel in order to gain access to the sliding door lower roller bracket bolts.
  3. Mark the location of the sliding door lower roller bracket to the sliding door with a grease pencil.
  4. Support the sliding door.
    5. Fig 1: Identifying Sliding Door Catch With Reinforcement Channel
    GM1480612Courtesy of GENERAL MOTORS CORP.
  5. Remove the sliding door catch (1) with the reinforcement channel bolt (2) at the sliding door lower track.
    6. Fig 2: Identifying Sliding Door Lower Bracket Bolts
    GM1480628Courtesy of GENERAL MOTORS CORP.
  6. Remove the sliding door lower roller bracket vertical bolts.
  7. Remove the sliding door lower roller bracket from the lower track.
scientia non olet · About LEMON Manuals