LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 174 (Door System, Mirror System & Window System) >> Repair Instructions >> Inside Handle Replacement - Sliding Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.
  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Use J 42506-A  in order to remove the inside door handle clip. See Special Tools .
    3. Fig 1: Identifying Inside Handle
    GM320002Courtesy of GENERAL MOTORS CORP.
  3. Remove the inside handle from the sliding door.
scientia non olet · About LEMON Manuals