Removal Procedure
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
- If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
- Open the sliding door.
- Protect and support the sliding door at the bottom edge.
- Remove the pin (1) from the sliding door center roller bracket.
- Remove the sliding door lower roller bracket. Refer to Roller Bracket Replacement - Lower .
- Remove the sliding door upper roller bracket. Refer to Roller Bracket Replacement - Upper .
- With the aid of an assistant, remove the sliding door from the roller brackets.
Transfer parts as necessary to the new door.
IMPORTANT:
By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.