Test Description
WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
The numbers below refer to the step numbers on the diagnostic table.
- 3: Tests the PSDMs ability to provide power and ground to energize the clutch.
DTC B1293: Power Sliding Door Clutch Control Circuit
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Power Sliding Door (PSD) Schematics Connector End View Reference: Power Door Systems Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Step 3 | Go to Step 5 |
| 3 | Inspect and if possible repair any damage to the motor and clutch pigtail harnesses or connectors. Refer to Wiring Repairs
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Replace the PSD motor and clutch assembly. Refer to Motor Clutch Replacement - Power Sliding Door (With RPO E59 LH) or Motor Clutch Replacement - Power Sliding Door (With RPO E58 RH) . Is the repair complete? |
Go to Step 6 | - |
| 5 | Replace the PSDM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup and programming. Is the repair complete? |
Go to Step 6 | - |
| 6 | Re-initialize the power sliding door and operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |