LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Lighting Systems) >> Repair Instructions >> Headlamp Aiming (European) >> Headlamp Aiming Procedure

Headlamp Aiming Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. Fig 1: Measuring Distance Between Headlamps Face & Aiming Screen
    GM418400Courtesy of GENERAL MOTORS CORP.
  2. Measure from the floor to the center of the headlamp bulb.
  3. At the screen, measure from the floor and place the horizontal tape at the measured distance.
  4. Measure from the reference line on the floor to the left headlamp bulb centerline.
  5. At the screen, measure from the reference line and place the vertical tape at the measured distance.
  6. Measure from the reference line on the floor to the right headlamp bulb centerline.
    7. Fig 2: Measuring Headlamp Reference Line
    GM1480015Courtesy of GENERAL MOTORS CORP.
  7. At the screen, measure from the reference line and place the vertical tape at the measured distance.
    8. IMPORTANT: Do not cover the headlamp. This may cause excessive heat build up. Use a piece of cardboard forward of the headlamp to block the light.
  8. Turn ON the low beam headlamps and block the light from projecting onto the screen from the passenger side headlamp.
  9. Adjust the vertical aim of the headlamps to the specifications required by the state and the local authorities or as shown in step number 8.
  10. Rotate the headlamp adjuster to change the vertical aim of the headlamp.
  11. Repeat the aiming procedure for the passenger side headlamp while blocking the light from projecting onto the screen from the driver side headlamp.
  12. Turn the headlamps OFF.
  13. Close the hood.
scientia non olet · About LEMON Manuals