Visual Aiming Preparation Procedure

Headlamp aim should be checked:

• When a new headlamp capsule is installed
• If service or repairs to the front end area have disturbed the headlamps or their mounting

The aiming screen and placement should meet the following criteria:

• The area will consist of a level surface large enough to allow for a vehicle and an additional 7.62 m (25 ft) measured from the face of the lamps to the front of the aiming screen.
• The screen will be 1.52 m (5 ft) high x 3.66 m (12 ft) wide with a matte white surface well shaded from extraneous light and properly adjusted to the floor on which the vehicle stands. Provisions should be made so the aiming screen can be aligned parallel with the vehicle.
• The screen shall be provided with a fixed vertical centerline, 2 laterally adjustable vertical tapes and one vertically adjustable horizontal tape.
• If a regular commercial aiming screen is not available, the screen may consist of a vertical wall having a clear uninterrupted area approximately 1.83 m (6 ft) high and 3.66 m (12 ft) wide. The surface should be finished with a washable non-gloss white paint.
Fig 1: Headlamp Aiming/Adjusting
Courtesy of GENERAL MOTORS CORP.
• After the aiming screen has been set up in its permanent location, paint a reference line on the floor directly under the lens of the lamps to indicate the proper location of the headlamps when they are being aimed:
  • Distance between headlamps (4)
  • Center line of screen (5)
  • Adjustable vertical pointer (2)
  • Adjustable horizontal tape (6)
  • Diagram of light screen (7)
  • 7.62 m (25 ft) (9)
  • Car axis (8)
  • Horizontal center line of lamps (1)

Prior to aiming the headlamps, the following steps must be taken:

1. Remove any snow, ice or mud from the vehicle, if applicable.
2. The vehicle must have a full tank of gas.
3. Stop all other work on the vehicle.
4. If any service has been performed on the vehicle, make sure that all of the components are back in their original place.
5. The vehicle must be on a level surface.
Fig 2: Identifying Headlamp Light Pattern
Courtesy of GENERAL MOTORS CORP.
6. The vehicle left tires must be aligned with the reference line extending from the screen with the headlamps aligned with the reference line.
7. Do not load any cargo in the vehicle.
8. The vehicle must contain one person or 72.56 kg (160 lb) on the driver seat.
9. Inflate the tires to the proper pressure.
10. Simulate the vehicle loads if the intended use of the vehicle is for hauling heavy loads or towing a trailer.
11. Rock the vehicle in order to stabilize the suspension.
12. Turn ON the headlamps to low beam and observe the left and the top edges of the high intensity zone on the screen. The edges of the high intensity zone should fall within the specifications.